Home / Approved Trainer / USA LIFTING & RIGGING SPECIALIZED INSTRUCTOR COURSE IN ISLAMABAD

USA LIFTING & RIGGING SPECIALIZED INSTRUCTOR COURSE IN ISLAMABAD

USA LIFTING & RIGGING SPECIALIZED INSTRUCTOR COURSE IN ISLAMABAD

OSHA and ANSI require that HSE, Work Supervisors and Crane operators receive training to operate a crane. Lifting and rigging operations before they are considered qualified. Rigging personnel must also learn basic safe work practices when lifting and landing loads with a crane. Participants will learn about types of cranes, boom trucks, and basic math used to calculate capacities and volume. In addition, participants will learn how to use rigging hardware and slings. Signaling responsibilities, communication, and voice commands are also covered. To successfully complete this certification course, participants must pass all hands-on evaluations and a written exit exam with a score of 80% or above.

Goals/Objectives/Student Learning Outcomes
Describe some of the common errors that cause most crane and rigging accidents
Describe and demonstrate at least six safe work practices for working with and around cranes and explain why each is important
Identify at least six different types of cranes, using scenarios involving cranes working near high voltage lines, give the minimum clearance between the crane and lines based on OSHA standards
Define the regulations; demonstrate safe work practices to rigging and hoisting, responsibilities of signal person and communicating with operator

Calculate the SWL, and WLL of slings, Understand the safety factor of lifting accessories and equipment
Understand the requirements of applicable legislation to lifting and rigging operations. Carry out pre-use inspection for a lifting and rigging operation. Recommend that equipment and accessories be discarded where applicable. Identify the risks associated in a rigging and lifting operation. Master the different types of slings use in a lifting and rigging operation. Identify the types, features and limitations of slings use in lifting operations. Understand the elements for calculating and sizing a slings use for lifting and rig

Textbooks/Readings/Materials:
LIUNA: 40-Hour Hoisting & Rigging IG
LIUNA: 40-Hour Hoisting & Rigging PG
Hoisting& Rigging Student Handout Packet
LIUNA: Hoisting & Rigging PowerPoint
DVD: Hoisting & Rigging Procedures
DVD: Signaling
Syllabus Outlines
Introduction to LOLER, PUWER and HASWA legislation
Accessories and equipment use during lifting and rigging operations.
Hardware slings, ropes, flat woven webbing slings, wire rope, chains, liaison Bodies and Accessories
Inspection and correct use of tirfors, chain blocks, pull lifts, beam clamps, wire rope.
Examination of rigging and lifting equipment
Utilizing recommend rigging methods to move various items
The Lifting plan
Identification and Marking
Mechanical strength of equipment/accessories and their safety factor.
Elements for calculating and sizing a sling
Commissioning, test before use
Use of protective slings to the edges Nodes
Protection against abrasion
Maintenance of slings
Precautions to be taken by the slinger
The gesture of command and control

Total Course Fee: 800 USD
For Registration Please Contact Us : 0336-3333792, 051-8314594

About admin

institute

One comment

  1. Just wish to say your article is as astonishing.
    The clearness in your post is simply nice and i can assume you’re an expert on this
    subject. Fine with your permission allow me to grab your feed to keep up to date with forthcoming post.
    Thanks a million and please carry on the rewarding work.

Leave a Reply

Your email address will not be published. Required fields are marked *