OSHA

OSHA USA COURSE

This course is designed for individuals interested in teaching the 10 and 30-hour general industry safety and health Outreach training program to their employees and other interested groups. Using the OSHA General Industry Standards as a guide, special emphasis is placed on those topics required in the 10- and 30-hour programs as well as those which are most hazardous. Students are briefed on effective instructional approaches and use of visual aids and handouts. This course allows the student to become a trainer in the OSHA Outreach Training Program, to conduct both 10- and 30-hour General Industry Outreach classes, and to issue cards to participants after verifying course completion. Students who wish to participate as authorized trainers in the OSHA Outreach Training Program must prepare a presentation on an assigned OSHA General Industry Outreach Training Program topic individually or as part of a group and successfully pass a written exam at the end of the course.

The OSHA Outreach Training Program for the Construction Industry provides training for workers and employers on the recognition, avoidance, abatement, and prevention of safety and health hazards in workplaces in the construction industry.

About admin

institute

3 comments

  1. I am Ali hamza tahir, do you offer Nebosh igc course training in mardan, what is the date of next session please.

  2. Sorry, MR.ALI we are not offering. thanks

  3. SUB CONTRACTOR WORKSITE SAFETY
    Each company or contractor has the responsibility to make sure all employees follow safety and health rules and any specific or special rules of the jobsite.

    Each contractor should have a written Injury and Illness Prevention Plan for employees that documents the job safety and health requirements and to make sure all employees are trained in these requirements. Employee safety training, regardless of job experience is mandatory. General safe work practices are important, as is specific training for those jobs with potential special hazards, such as crane operation, powder actuated tools, welding, grinding or other specific type jobs. Each employer on the job site is responsible for all training documentation, OSHA recordkeeping and other required documentation. All employers on a job site are responsible for a written and properly implemented Hazard Communications program, which includes Material Safety Data Sheets for each chemical on the worksite.

    Generally, all persons shall follow safe work practices, render every possible aid to safe operations and report all unsafe conditions or practices to their foreman or site superintendent so they can be corrected. Foremen or supervisors shall insist on employees observing and obeying every applicable company, state or federal regulation and order as is necessary to the safe conduct of the work and shall take such action as is necessary to obtain compliance.

    No burning, welding or other source of ignition shall be applied to any enclosed tank or vessel, even if there are some openings, until it has first been determined that no possibility of explosion exists and authority for the work is obtained from the foreman or superintendent.

    Only appropriate tools for each job will be used. All tools and equipment shall be maintained in good condition. Damaged tools or equipment shall be removed from service and tagged defective and not used until repaired or replaced. Portable electric tools shall not be lifted or lowered by means of the power cord, however, they can be lifted with ropes. Electric cords shall not be exposed to damage from vehicles. Workers shall not handle or tamper with any electrical equipment, machinery, or air or water lines in a manner not within the scope of their duties, unless they have received proper training and instructions from their foreman.

Leave a Reply

Your email address will not be published. Required fields are marked *